Removal Of Dvd Deck Parts - Toshiba SD-25VLSR Service Manual

3. REMOVAL OF DVD DECK PARTS

NOTE
1. Do not disassemble the DVD DECK PARTS except
listed parts here. Minute adjustments are needed if the
disassemble is done. If the repair is needed except
listed parts, replace the DVD MECHA ASS'Y.
3-1: TRAY (Refer to Fig. 3-1-A)
1. Set the Tray opened. (Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY)
Unlock the 2 supports 1 and remove the Tray.
2.
1
Tray
NOTE
1. In case of the Tray installation, install them as the
circled section of Fig. 3-1-B so that the each markers
are met.
Main Frame Ass'y
3-2: MAIN CHASSIS ASS'Y (Refer to Fig. 3-2-A)
Remove the screw 1.
1.
Unlock the 2 supports 2.
2.
3. Remove the Insulator (R) from the Main Frame Ass'y.
4. Remove the Main Chassis Ass'y.
Main Frame Ass'y
Main Chassis Ass'y
• Screw Torque: 2.0 ± 0.3kgf•cm
DISASSEMBLY INSTRUCTIONS
Main Frame Ass'y
1
Fig. 3-1-A
Tray
Fig. 3-1-B
1
2
2
Insulator (R)
Fig. 3-2-A
NOTE
1. In case of the Main Chassis Ass'y, install it from (1) to
(4) in order. (Refer to Fig. 3-2-B)
2. In case of the Main Chassis Ass'y installation, hook the
wire on the Main Frame Ass'y as shown Fig. 3-2-C.
Main Frame Ass'y (Bottom Side)
(3)
(2)
(4)
3-3: LOADING MOTOR PCB ASS'Y/ LOADING BELT
(Refer to Fig. 3-3-A)
1. Remove the Loading Belt.
Remove the screw 1.
2.
Remove the 2 screws 2.
3.
4. Remove the Loading Motor PCB Ass'y.
5. Remove the Pulley Gear.
Loading Belt
• Screw Torque: 2.5 ± 0.3kgf•cm (Screw 1)
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw 2)
B3-1
(3)
Rack Loading
(3)
Traverse Holder
(1)
Main Chassis Ass'y
(4)
Check Lock
Main Frame Ass'y
Check Hook
2
2
Main Frame Ass'y
Pulley Gear
Loading Motor PCB Ass'y
1
Fig. 3-2-B
Fig. 3-2-C
Fig. 3-3-A