Euro Channel And Floor Box Versions - Extron electronics RGB 460xi Series User Manual

im Vertrieb von

Euro Channel and Floor Box Versions

The RGB 460xi and RGB 468xi are available in a Euro Channel
(EC) version, the RGB 460xi is available in two floor box models
(MK and FSR), and the RGB 468xi AKM UK is designed for
Ackermann floor boxes. (See appendix A for part numbers.)
The front and rear panel features, cabling requirements, and
testing/troubleshooting procedures are identical to the
descriptions shown in this chapter for the wall box models. For
installation instructions, see the RGB 400xi Series installation
guide that addresses your specific requirements.
Mounting Adapter Plates (AAPs/MAAPs)
All AAPs/MAAPs should be mounted before the interface is
tested or installed in a wall or furniture. Each AAP/MAAP has
standoffs (screws built into the rear panel) and nuts/hex screws,
which can be used to secure the AAP/MAAP to the interface.
1.
2.
4-gang Wall Box
Mounting an adapter plate (AAP shown)
3.
www.camboard.de
2-10
CAMBOARD Electronics
Insert the AAP/MAAP standoffs into screw holes in the
interface.
Using the #4-40 nuts (standard AAPs) or the 3/32" hex
screws (MAAPs) provided, secure the AAP/MAAP to the
interface.
#4-40 Nut w/ Captive
Washer
Repeat steps 1 and 2 to mount other AAPs/MAAPs. Cover
any openings in the interface with blank AAP/MAAP
plates.
Tel. 07131 911201 ce-info@camboard.de
RGB 460xi Series • Installation and Operation
Fax 07131 911203
Note: The RGB 468 Mxi (not
shown) uses hex screws
that mount the MAAPs
from the front, instead of
nuts, which mount the
AAPs from the rear (as
shown).
IF T
S H
H .
O R
N IT TM
S P
M O
A D
H
W IT
/M A X
6 8
M IN B 4
T
P U R G
IN
O R
N IT
M O
D IO
O R A U
N IT
M O
N O
RGB 468xi