Extron electronics RGB 460xi Series User Manual page 17

im Vertrieb von CAMBOARD Electronics
Power connector — Connect a 9VDC to 24VDC power supply
4
Power
Audio output connector — Insert wires into and tighten the
5
screws on this 3.5 mm, 5-pole, direct insertion captive screw
connector for unbalanced or balanced audio output. Wire the
connector as shown here.
Unbalanced Output
Sleeve (s)
CAUTION
Composite video pass-through BNC connector — A male BNC
6
connector attaches here.
S-video pass-through 4-pin mini DIN connector — A male
7
4-pin mini DIN connector attaches here.
Balanced active audio connector — Insert wires into and
8
tighten the screws on this 3.5 mm, 5-pole, direct insertion
captive screw connector for balanced active audio output. Wire
the connector as shown above.
Network pass-through RJ-45 connector — If this connector is
9
not required, a blank cover is supplied to fill this faceplate
opening.
www.camboard.de Tel. 07131 911201
RGB 460xi Series • Installation and Operation
Fax 07131 911203
If the signal cable between the interface and the output
device is shorter than approximately 125 feet, and the
gain switch is set to Medium or Maximum, the image
may be overcompensated. If the edges of the image seem
to exceed their boundaries, or if thin lines and sharp
edges look thick and fuzzy, try changing the gain/
peaking setting. The gain switch will be inaccessible
after installation, so adjust the gain before installing
the interface into a wall or furniture.
to this 3.5 mm, 2-pole, direct insertion captive
screw connector. Wire the connector as
+ or –
– or +
shown here. Polarity is not important.
See Caution
Tip
See Caution
Tip
Connect the sleeve to ground (Gnd). Connecting
the sleeve to a negative (-) terminal will damage the
audio output circuits.
ce-info@camboard.de
Balanced Output
Ring
Tip
Sleeve (s)
Ring
Tip
2-9