Technical Specifications - Kärcher FC 3d Cordless Manual

Hide thumbs Also See for FC 3d Cordless:

Instruction manual (96 pages)

Table of Contents

Appliance is not sucking up dirt

No water in the fresh water tank.

 Refill water

Fresh water tank does not fit properly in the device.

 Insert the fresh water tank so that it sits snugly in

the appliance.

Cleaning rollers missing or not fitted correctly.

 Fit the cleaning rollers or turn them onto the roller

holder up to the mechanical stop.

Cleaning rollers are contaminated or worn.

 Clean the cleaning rollers.

 Replace the cleaning rollers.

The detergent has been forgotten, an incorrect dosage

is being used or the incorrect detergent is being used

 Use only KÄRCHER detergent and be sure to use

the correct dosage.

Floor head cover not installed correctly

 Check that the floor head cover is correctly seated.

For this, remove the cover and then fit it back in

place.

Formation of foam on the floor head and the

Note

Slight foam formation in the floor head during operation

is normal and does not impair functionality. Further

measures are only necessary when there is excessive

foam formation (e.g. streaks of foam on the floor).

Incorrect detergent or incorrect dosage.

 Use only KÄRCHER detergent and be sure to use

the correct dosage.

Device operation is based on the cleaning rollers re-

moving dirt. Dirt and detergent residues from floor cov-

erings collect in the waste water tank. This can lead to

foam formation under some circumstances.

 Remove all dirt and detergent residues from the

rollers using water.

Illustration

 In the event of excessive foam formation, add

FoamStop to the empty waste water tank before

starting cleaning. Please observe the dosage in-

structions on the bottle label.

Poor cleaning result

The rollers are dirty.

 Clean the rollers.

Rollers are not being sufficiently moistened.

 Moisten the rollers by moving back and forth over

the same position.

Incorrect detergent or incorrect dosage.

 Use only KÄRCHER detergent and be sure to use

the correct dosage.

Foreign detergents are present on the floor.

 Remove all detergent residues from the rollers us-

ing water.

 Clean the floor several times using the device and

clean rollers, without using detergent. This re-

moves detergent residues from the floor

floor

Rollers do not turn

Rollers are blocked.

 Remove rollers and check if an object has become

stuck in the rollers.

 Check that the rollers are screwed in as far as they

will go onto the roller holder.

 Check that the floor head cover is correctly seated.

For this, remove the cover and then fit it back in

place.

Water vacuuming not optimum

Floor head cover not installed correctly

 Check that the floor head cover is correctly seated.

For this, remove the cover and then fit it back in

place.

The rollers are worn out.

 Replace the rollers.

Appliance is leaking waste water.

Waste water tank is overfilled.

 Empty the waste water tank right away.

Waste water tank does not fit properly in the appliance.

 Check that the floor head cover is firmly seated on

the waste water tank.

 Check that the waste water tank flaps are correctly

closed.