Maintenance; Verifying Temperature; Periodic Cleaning (Annually); Heater Calibration (Delta Controls) - CLEAN ROOM DEVICES CRD216SS Operation Manual

4.0 Maintenance

4.1

Verifying Temperature

 To verify the operational temperature, place a ring terminal measuring probe between the
thermocouple and the upper jaw, as shown below:
Spade-head probe and connector
4.2

Periodic Cleaning (annually)

 Wipe down outer surfaces with alcohol, septihol or mild detergents as required.

Ensure the control box does not have a significant amount of dust or debris buildup
within it.
4.3 Heater calibration for Delta DTB Controller
 Adjusting the temperature on the Delta controls is a simple task.
 Using the "UP" and "DOWN" arrows, adjust the temperature to the desired setting and
press the "SET" button to store your settings. Figure 4.3.1
Probe placed between thermocouple & jaw
14