Salamander UNIFI Assembly Instruction

Meeting table

Assembly Instruction

UNIFI™ MEETING TABLE

LIMITED WARRANTY FOR COMMERCIAL UNIFI MEETING TABLE

Salamander is proud to stand behind our products with industry-leading warranties. Should you ever encounter

any problem with your Salamander product, let us know. We are here to make it right. 1.860.761.9500

Full warranty including limitations and warranty claim information may be found at

www.salamandercommercial.com/warranty

Salamander Unifi Meeting Table

1 of 4

501-750 [9.20]

Table of Contents

Need help?

Do you have a question about the UNIFI and is the answer not in the manual?

Page 1 Salamander is proud to stand behind our products with industry-leading warranties. Should you ever encounter any problem with your Salamander product, let us know. We are here to make it right. 1.860.761.9500 Full warranty including limitations and warranty claim information may be found at www.salamandercommercial.com/warranty...
Page 2 Insert two 1/4-20 x 2" joint connector bolts through the top holes and two bolts through the third hole from the bottom. Secure the two table halves using the hex key. 1/4-20 x 2" Joint Connector Bolt Salamander Unifi Meeting Table 2 of 4 501-750 [9.20]...
Page 3 Joint Pockets. D. Install Joint Pocket Kits where access is available. The table top will have to be carefully moved to provide access to some of the Joint Pockets. Salamander Unifi Meeting Table 3 of 4 501-750 [9.20]...
Page 4 FIGURE 3 FIGURE 2 NOTE: If both panels are locked then the top must be Shoulder Bolt removed to remove a panel. Panel Lock (If desired) LEVEL TABLE Adjust levelers as needed. Salamander Unifi Meeting Table 4 of 4 501-750 [9.20]...