Advertisement
Quick Links
SYNERGY TWIN UNIT - SN20 / SN30 / SN40
WARNING: If you are installing accessories such as doors or drawers to the base unit, read all
!
instructions for the accessory and install in conjunction with these instructions.
CONNECTOR BOLTS
TOP SHELF
HEAVY SHELF BRACKET
BOTTOM SHELF
* Diagram: Synergy 40 Twin Unit
SHELF PEG
LOW HEAD SCREW
WASHER
HEX NUT
LEVELER FOOT
ALUMINUM POSTS
RUBBER TAB
FLAT NUT
Doc No. 500-350 1 of 4
Advertisement
Related Manuals for Salamander SN20
Summary of Contents for Salamander SN20
- Page 1 SYNERGY TWIN UNIT - SN20 / SN30 / SN40 WARNING: If you are installing accessories such as doors or drawers to the base unit, read all instructions for the accessory and install in conjunction with these instructions. CONNECTOR BOLTS TOP SHELF...
-
Page 2: Limited Warranty
Limited Warranty For five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. - Page 3 Connect Posts to Bottom Shelf Add Shelf Pegs WARNING: If you are installing an optional door or drawer refer to WARNING: Tighten by screwing the leveler foot NOT the post. specific instructions before proceeding. Square Post Square the post to the bottom shelf. Insert all shelf pegs and heavy shelf brackets (SN40 only) down each post.
- Page 4 Attach Rear Panel Adjust Shelf Pegs / Add Shelves Insert Hardware Adjusting Shelves Combine the 1” threaded studs Insert peg down the post channel with the flat nuts. Slide hardware and position the peg through the into rear channel Spacer and tighten. You may also consider using books or CD's for shelf spacing.
Need help?
Do you have a question about the SN20 and is the answer not in the manual?
Questions and answers