1. Manuals
  2. Brands
  3. Salamander Manuals
  4. Indoor Furnishing
  5. SYNERGY 229
  6. Assembly

Salamander SYNERGY 229 Assembly

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

SYNERGY 229
Twin Assembly
Includes:
(1) Twin 20 Unit
(2) S20 Side Panels
(2) S10 Doors
(1) Double-Width Shelf

Limited Warranty

Five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other
equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in
a shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only.
Salamander Designs Ltd.
•
800-535-5659

BEFORE YOU BEGIN:

!
!
• Unpack all parts and read instructions carefully before beginning.
• Shelf pegs and door hinges must slide into the channels of the post in the correct order.
They cannot be removed individually without disassembling the whole unit.
1

Connect Posts to Bottom Shelf

A
.
Square Post
Square the post to the bottom shelf.
B
.
Connect Post
Screw foot with metal washer through bottom
shelf and into the end of each extruded post.
Hand tighten fully and use wrench to tighten
nut onto underside of shelf.
WARNING: Tighten by screwing the leveler foot NOT the post.
•
www.SalamanderDesigns.com
©2008 Salamander Designs Ltd.
Leveler Foot
Synergy System, Patented.
TM
Short Post
Washer
Hex Nut
Doc No. 500-615/v8.12
229 -1/4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SYNERGY 229 and is the answer not in the manual?

Questions and answers

Related Manuals for Salamander SYNERGY 229

Summary of Contents for Salamander SYNERGY 229

  • Page 1: Before You Begin

    Limited Warranty Five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in a shipment not in original packaging shall be the responsibility of the owner.
  • Page 2 Installing Hardware Attach Rear Panels Insert Hardware Combine the 1” threaded studs with flat nuts. Slide 2 sets of hardware down the two outside posts and 4 sets down the center post. Allow studs to remain loose at bottom of post. 8"...
  • Page 3 Placing Shelves Sides and Top Assembly Insert Side Panels Carefully slide side panels down outside posts. Be sure the posts are square to the bottom shelf to prevent any damage to side panels. Secure Top Secure top with the 5 connector bolts. Place the plastic plugs in the front center hole.
  • Page 4 Attach Doors Note: The hinge can be separated by pulling the black tab and pulling apart the hinge from the hinge Attach Hinges to Door Frames base. Separated hinges snap back together. Insert the hinges into the corresponding holes on the doors. Turn the screws 1/4 turn to the right to lock hinges in place.

Table of Contents