74” Allied Snowblower WARRANTY REGISTRATION AND POLICY Buhler Manufacturing products are warranted for a period of twelve (12) months from original date of purchase, by original purchaser, to be free from defects in material and workmanship under correct, normal agricultural use and proper applications.
74” Allied Snowblower This manual is for 74" snowblowers with an open gear gearbox. When ordering parts, specify model number and serial number. The snowblower is t h e push type and will mount to a tractor with a 540 rpm PTO. It is supplied with category 1 pins and also bushings, which convert the pins to a category 2.
OPERATING INSTRUCTIONS Do not operate the blower in the fully raised position. The three-point hitch on some tractors raises high enough to cause the PTO shaft to bind. This can cause damage to the PTO shaft and/or to the hitch and pins. ALERT: PTO shaft angle should not exceed 20 degrees for optimum performance and life.
ASSEMBLY INSTRUCTIONS 1. Turn the bottom tube weldments (#9) as shown in drawing and slide them into the sleeve welded to the main body. These tubes have holes for two positions. The correct position for each individual tractor will be determined when mounting the snowblower on the tractor.
Page 6
ASSEMBLY INSTRUCTIONS – cont’d. 7. Mounting blower on tractor: Mount the blower on a tractor with a category 1 or category 2 hitch. Using tape or bright colored marking pen, mark on the outer shields the position where the shaft is completely pushed together and the position where you have a 4"...
WHEN ORDERING PARTS Always give your dealer the Model, Color and Serial Number of your machine to assist him in ordering and obtaining the correct parts. Use the exploded view and tabular listing of the area of interest to exactly identify the required part. ITEM PART # DESCRIPTION 907241A...
Page 10
901940 5/16'' x 1 1/4'' Key 965413A Drive Shaft 1 1/4'' x 37 1/4'' 936402 PTO Safety Chain 81527 1/4'' x 1'' Hex Bolt (pl) 84498 1/4'' Lock Nut (pl) 968627 1 1/2'' Bearing With Collar 967260 1 1/2'' Bearing Retainer (Set) 965822 Fan (Standard 3-Blade) 965447...
Page 11
961012 #16 Hair Pin Clip 961658 1/4'' Cable Clamp 961876 1/2'' x 1 1/2'' Clevis Pin (pl) 902407 Skid Plate Weldment 9812487 1 1/4'' x 10ga Narrow Rim Washer (pl) 967110 1 1/4'' x 14ga Narrow Rim Washer (pl) 9812439 1 1/4'' x 18ga Narrow Rim Washer (pl) 967135 1 1/2'' x 10ga Narrow Rim Washer (pl)