Page 2
50” & 60” Allied Snowblower WARRANTY REGISTRATION AND POLICY Buhler Manufacturing products are warranted for a period of twelve (12) months from original date of purchase, by original purchaser, to be free from defects in material and workmanship under correct, normal agricultural use and proper applications.
Page 3
50” & 60” Allied Snowblower ALLIED SNOWBLOWER This manual is for both 50" and 60" snowblowers. When ordering parts, specify model number and serial number. Both snowblowers are the push type and will mount to a tractor with a category 1 three-point hitch or a category 1 Quick Hitch and 540 rpm PTO. Both snowblowers come with a hand crank chute control as standard.
Page 4
Do not operate the blower in the fully raised position. The three-point hitch on some tractors raises high enough to cause the PTO shaft to bind. This can cause damage to the PTO shaft and/or to the hitch and pins. NOTE: PTO shaft angle should not exceed 20°...
Page 5
OPERATING INSTRUCTIONS – cont’d. CAUTION: Always check to see that both ends of the PTO shaft are securely attached as per instructions every time you are preparing to use the snowblower. When replacing bearings or tightening a loose bearing collar, always tighten collar in the direction of shaft rotation using a center punch or a similar tool.
Page 6
50" & 60" SNOWBLOWER ASSEMBLY INSTRUCTIONS Mount the discharge spout (#2) using the spout clamp (#3) bolted to the spout ring on the snowblower. Lubricate the spout ring and clamp. NOTE: A hydraulic cylinder and hose kit to control the spout deflector is available as an option.
Page 7
ASSEMBLY INSTRUCTIONS – cont’d. Hydraulic Control Assembly: (option) Bolt the hydraulic swivel assembly (#21) to the back of the fan housing on the left side using ½” x 1 ¼” hex bolts, lock washers and hex nuts. Bolt the cylinder mounting bracket (#23) to the back of the fan housing on the right side using the same size hex bolts.
Page 10
WHEN ORDERING PARTS Always give your dealer the Model, Color and Serial Number of your machine to assist him in ordering and obtaining the correct parts. Use the exploded view and tabular listing of the area of interest to exactly identify the required part. ITEM PART # DESCRIPTION 905595A...
Page 11
87553 1/2'' x 1 3/4'' Hex Bolt (pl) 81549 5/16'' x 3/4'' Hex Bolt (pl) 81569 5/16'' Lock Washer (pl) 81568 5/16'' Hex Nut (pl) 965630 Fan (50'') (Standard 3-Blade) 965445 Fan (50'') (4-Blade) 965642 Fan (60'') (Standard 3-Blade) 907118 Fan (60'') (4-Blade) 965505 Auger (50'')
Page 12
961012 #16 Hair Pin Clip 961876 1/2'' x 1 1/2'' Clevis Pin (pl) 901435 1/2'' X 2 1/2'' Clevis Pin (pl) 902477 Skid Plate Weldt 812026 5/16'' X 1'' Hex Bolt (pl) 9812426 1/4'' x 1 3/4'' Spring Pin (pl) 936402 PTO Safety Chain 9812487...
Need help?
Do you have a question about the 50-inch, 60-inch and is the answer not in the manual?
Questions and answers