Page 2
96” Allied Snowblower WARRANTY REGISTRATION AND POLICY Buhler Manufacturing products are warranted for a period of twelve (12) months from original date of purchase, by original purchaser, to be free from defects in material and workmanship under correct, normal agricultural use and proper applications.
Page 3
96” Allied Snowblower SNOWBLOWER This manual is for 96" Allied Snowblower with a quick coupling hitch. With this hitch, the blower can be mounted on a tractor with either a quick hitch or the standard three-point hitch. All 96" Allied snowblowers have a sealed oil bath gearbox. The snowblower is the push type and will mount to a tractor with 540 rpm PTO.
Page 4
OPERATING INSTRUCTIONS Do not operate the blower in the fully raised position. The three-point hitch on some tractors rises high enough to cause the PTO shaft to bind. This can cause damage to the PTO shaft and/or to the hitch and pins. Depth of cut can be partially controlled by tilting the blower forward or backward.
Page 5
OPERATING INSTRUCTIONS – cont’d Shear Sprocket: The shear sprocket (#24) should be checked at the beginning of every season to make sure it will spin freely. With time this sprocket could corrode and seize which will not allow the shear bolt to break if something jams in the snowblower auger.
Page 6
ASSEMBLY INSTRUCTIONS Fasten the two quick hitch arms (#57 & #58, left and right) to the main body. Use eight 5/8” x 1 ¼” hex bolts, lock washers and hex nuts. Note: Lift arms for quick coupling hitch are 30 ¾” long versus 35” for the standard three point hitch.
Page 7
ASSEMBLY INSTRUCTIONS – cont’d. Mounting blower on tractor: The pins supplied with the snowblower are for a category 2 quick hitch. The quick coupling hitch has two holes both at the top of the hitch and at each lift arm. When using a quick coupler, the pins must be in the inside set of holes.
Page 8
96” Allied Snowblower ASSEMBLY INSTRUCTIONS – cont’d. PTO SHIELD All snowblowers are supplied with a PTO shield (#61). To install, remove the two rear bolts at the top of the gearbox (#38). Bolt the PTO shield to the gearbox by the hinges using these same bolts. A utility spring (#62) keeps the shield in place.
Page 11
WHEN ORDERING PARTS Always give your dealer the Model and Serial Number of your machine to assist him in ordering and obtaining the correct parts. Use the exploded view and tabular listing of the area of interest to exactly identify the required part. 96'' ALLIED SNOWBLOWERS ITEM PART # DESCRIPTION...
Page 12
965919A Drive Shaft Guard 965964 1/4'' Cable x 70'' Long 965923 Swivel Arm 967140 1'' x 10ga Narrow Rim Washer (pl) BU50505 Gearbox Complete w/o Oil F0585 PTO Shaft Complete 965925A Drive Shaft 968807 3/8'' x 3/8'' x 2'' Key 81627 1/2'' x 3'' Hex Bolt (pl) 902377...