Matrix COSEC ARGO Manual page 3

Pre-Installation Safety Instruction
1. Do not install the device in extremely hot temperature or under direct
Sunlight on turnstile or at extra bright places. This may affect the LCD
and Camera sensor of device. You can do indoor installation or on the
turnstile under the roof as shown in Figure 4.
Figure 4
2. You can mount the device on a flat surface such as a wall or near the
elevator, close to the access point (door) with surface wiring or
concealed wiring as shown in Figure 5.
3. Recommended height of the device from ground level is upto 120cm-
130cm maximum as shown in Figure 6.
4. Minimum recommended distance of the user's face from the camera
of the device is 30cm while maximum recommended is 120cm as shown
in Figure 6.
Figure 5
2
N ex
t
L ev
el
5
Figure 6
30cm
120cm
5. Do not install on unstable surfaces, near volatile inflammable materials,
areas where volatile gas is created, where ferromagnetic field or noise is
induced, where static is created, such as desks made of plastics, carpets.
6. As Device is IP65* certified, it is dust and splash proof but direct contact
of water droplets on lens can affect the FR performance of the device,
hence do not install the device in outdoor areas which may be exposed
to rain. You can do indoor installation or on the turnstile under the roof as
shown in Figure 7.
Figure 7
*
Certification in - Progress.
6