Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Matrix COSEC PANEL200
Summary of Contents for Matrix COSEC PANEL200
- Page 1 COSEC PANEL200 Quick Start...
-
Page 2: Table Of Contents
Please read this guide first for correct installation and retain it for future reference. The information The completely distributed database of COSEC Panel200 in this guide is prevailing at the time of publication. However, Matrix Comsec reserves the right to enables it to operate independently. All information make changes in product design and specifications without prior notice. -
Page 3: Why You Need Panel200
The Special Access Control features with infallible operation Ÿ A Stand-alone Computer A Wire Stripper Ÿ Ÿ are provided by COSEC Panel200. Few features are listed with a Web Browser to A Screw Driver Set Ÿ below: change the Network Insulation Tape Ÿ... -
Page 4: Mounting The Panel200
Mounting the Panel200 ALARM ALARM STATUS STATUS POWER POWER SAFETY INSTRUCTIONS Figure 1 Do not install the device: On unstable surfaces. Ÿ Where ferromagnetic field or noise is induced. Ÿ Where static is created, such as desks made of Ÿ plastic, carpets. -
Page 5: Connecting Interfaces With Panel200
Connecting Interfaces with Panel200 Connecting wires to AUX O/P/AUX I/P/RS-485 ports: NOTE Maximum 255 doors can be connected with the Panel200, using either Push back the orange lever of the connector of appropriate Ÿ Ethernet or RS-485 or both. port, using a blunt pin or a small flat screw driver. Insert the stripped end of the wire into the opening of the Ÿ... -
Page 6: Powering On The Device
Device State Status LED Red ON Orange blinking Power ON Sequence Apply 12V DC,2A power supply to the COSEC Panel200 and wait Idle-Online Green blinking for the reboot cycle to complete. At the time of device start up Red ON (when online with server) i.e. -
Page 7: Configuring Network Settings
Configuring Network Settings The COSEC Panel200 can be connected to the network over Ethernet. Connect the Ethernet cable to the Ethernet Port (RJ-45) and Power ON the Panel200. Enter the login credentials of the Panel200. Ÿ Default Username: Admin; User defined Password Click Login to access the Panel200 webpage. -
Page 8: Panel200 In Server Mode
Adding Panel200 in COSEC Server To use the Panel200 with COSEC server application, you must add the Panel200 in COSEC Server using following steps. Open the COSEC Server application on a browser. Ÿ Click Devices > Device List > Click the New icon. Ÿ... -
Page 9: Wall Mounting Template
Event Buffer 5,00,000 Communication Ethernet / RS-485 / Bluetooth / Wi-Fi Standalone: Provides a built in GUI to control Matrix Door Controllers and Users Mode of Operation Server: Used for feature and Capacity enhancement for Access Control and connected with COSEC... - Page 10 Wireless Technology and Frequency range WLAN2.4 GHz Band :2412MHz ~ 2472 MHZ Bluetooth : 2402~2480MHz Rated Power (EIRP) <20dBm Mode 802.11 b/g/n HT20/HT40 Bluetooth BR, EDR, LE v4..2 MATRIX COMSEC Head Office 394-GIDC, Makarpura, Vadodara - 390010, India Ph: (+91)1800-258-7747 Email: Support@MatrixComSec.com www.matrixaccesscontrol.com...
Need help?
Do you have a question about the COSEC PANEL200 and is the answer not in the manual?
Questions and answers