Verifying System Memory; Verifying System Memory In Setup; Testing Memory Using Epsa; System Error Messages - Dell OptiPlex 7050 Small Form Factor Owner's Manual

Table 26. Diagnostic error messages (continued)
Error messages
TIME-OF-DAY NOT SET-PLEASE RUN THE SYSTEM
SETUP PROGRAM
TIMER CHIP COUNTER 2 FAILED
UNEXPECTED INTERRUPT IN PROTECTED MODE
X:\ IS NOT ACCESSIBLE. THE DEVICE IS NOT
READY

Verifying system memory

Windows 10
1. Clickthe Windows button and select All Settings
2. Under System, click About.

Verifying system memory in setup

1. Turn on or restart your computer.
2. Perform one of the following actions after the Dell logo is displayed:
● With keyboard — Tap F2 until the Entering BIOS setup message appears. To enter the Boot selection menu, tap F12.
3. On the left pane, select Settings > General > System Information,
The memory information is displayed on the right pane.

Testing memory using ePSA

1. Turn on or restart your computer.
2. After the Dell logo is displayed:
a. Press F12.
b. Select ePSA diagnostics
The PreBoot System Assessment (ePSA) starts on your computer.
NOTE: If you wait too long and the operating system logo appears, continue to wait until you see the desktop. Turn off
the computer and try again.

System error messages

Table 27. System error messages
System message
Alert! Previous attempts at booting this
system have failed at checkpoint [nnnn]. For
help in resolving this problem, please note
this checkpoint and contact Dell Technical
Support
72 Troubleshooting your computer
Description
The time or date stored in the system setup program does
not match the system clock. Correct the settings for the Date
and Time options.
A chip on the system board may be malfunctioning. Run the
System Set tests in Dell Diagnostics.
The keyboard controller may be malfunctioning, or a memory
module may be loose. Run the System Memory tests and the
Keyboard Controller test in Dell Diagnostics or Contact
Dell.
Insert a disk into the drive and try again.
> System .
Description
The computer failed to complete the boot routine three
consecutive times for the same error.