Fitting The Child Into The Child Seat - Be Cool Vulcano Manual

INSTALLATION FROM 105 TO 150CM
Follow the same steps as before. In this case you
should not connect the Top Tether.
There is also the option of installing the seat only
with the car seat belt when using the 105 to 150cm
mode however where possible it is recommended to
use ISOFIX.
2. FITTING THE CHILD INTO THE CHILD
SEAT
The Vulcano Car Seat may be used for the following
height ranges:
76-105 cm using the 5-point safety harness
105-150 cm the safety harness must be stored away
and the child should be secured with the 3-point
vehicle seat belt.
IM 2210,00 VULCANO_ print.indd 31
SAFETY HARNESS 76-105cm (With ISOFIX + Topte-
ther + 5 point safety harness)
2. 1 Slacken the shoulder straps by pressing the
harness adjustment button (
pulling both shoulder straps forward below the chest
pads with your other hand.
Press the red release button and undo the harness.
Move the ends of the buckle to each side of the seat
so you can put the child in the seat.
Carefully place the child into the seat and pass both
arms through the harnesses.
Fit the shoulder strap tongues and together and then
push firmly into the crotch strap buckle until you
hear a click.
2. 2 Tighten harness by pulling the lower strap (
To get the child out of the seat follow the same
process in reverse.
10 ) at the same time,
11 ).
22/9/20 11:11
EN
31