Fastening The Child Into The Pluto Safety Seat - Be Cool Pluto Manual

There is also the possibility of installing the child seat
only with the car seat belt.
2. FASTENING THE CHILD INTO THE
SAFETY SEAT
The safety seat may be used for the following
weight ranges:
2a. 9 kg-18 kg using the safety harness
2b. 15 kg -36 kg the safely harness should be stored
away and the child should be secured with the
vehicle seat belt.
Storing the safety harness away:
Once the child has reached a weight of 18 kg (105 cm
approx.) the harness should be stored away and the
child should be secured with the vehicle seat belt.
2c. To store the harness away it needs to be fully
loosened first, lift the lid found in the cushion, and
store the buckle parts in the compartment. Then put
the cover back on the seat.
Safety harness: 9kg-18 kg
3a. Loosen the harness by pressing the button
and pulling the diagonal part of the harness straps.
Unfasten the buckle by pressing the red button. Move
the ends of the buckle to each side of the seat so you
can put the child in the seat. Position the child in the
seat and put the strap over him on the both sides,
and then fasten the buckle.
Tighten harness by pulling the lower strap A to
3b.
get the child out of the seat follow the same process
in reverse.
The strap is at the correct tension when you can place
a finger between the chili chest and the harness.
Make sure that the height of the harness is
2a.
correct as shown in the diagram. To get the child out
EN
31