Boss IR-200 Owner's Manual page 20

Configuring the Settings (Menu)
Parameter Value
CONTRAST 1–16: Here you can adjust the brightness of the
characters in the display.
(LCD CONTRAST)
MIDI
Parameter Value
This sets the MIDI channel used for receiving MIDI
messages.
Rx CH
(Rx CHANNEL)
1–16: Specifies the receive channel.
OFF: MIDI messages are not received.
Sets the MIDI channel used for transmitting MIDI
messages.
1–16:
Specifies the transmit channel.
Tx CH
(Tx CHANNEL)
Rx: Transmits on the same channel as the RX
CHANNEL.
OFF:
MIDI messages are not transmitted.
OFF, ON:
PC IN
are received (on/off ).
OFF, ON:
PC OUT
are transmitted (on/off ).
OFF, ON:
CC IN
received (on/off ).
OFF, ON:
CC OUT
transmitted (on/off ).
OFF, #1–31, #64–95:
GAIN CC
(AMP GAIN CC)
when the GAIN parameter is controlled via MIDI.
OFF, #1–31, #64–95:
LEVEL CC
(AMP LEVEL CC)
when the LEVEL parameter is controlled via MIDI.
20
Sets whether program change messages
Sets whether program change messages
Sets whether control change messages are
Sets whether control change messages are
Sets the CC number used
Sets the CC number used
Parameter Value
SOLO SW CC OFF, #1–31, #64–95:
when the SOLO switch is controlled via MIDI.
(AMP SOLO SW CC)
SOLO LV CC OFF, #1–31, #64–95:
when the SOLO LEVEL is controlled via MIDI.
(AMP SOLO LEVEL CC)
OFF, #1–31, #64–95:
DOWN SW CC
number used when the [I] switch is controlled
via MIDI.
OFF, #1–31, #64–95:
UP SW CC
when the [H] switch is controlled via MIDI.
OFF, #1–31, #64–95:
CTL 1 CC
when CTL 1 is controlled via MIDI.
OFF, #1–31, #64–95:
CTL 2 CC
when CTL 2 is controlled via MIDI.
OFF, #1–31, #64–95:
EXP CC
when EXP is controlled via MIDI.
OFF, #1–31, #64–95:
BYPASS ON/OFF CC
when BYPASS is controlled via MIDI.
OFF, USB, MIDI, U+M:
MIDI THRU to output MIDI messages that are input to the MIDI
IN connector.
OFF, USB, MIDI, U+M:
USB THRU to output MIDI messages that are input to the USB
connector.
Sets the CC number used
Sets the CC number used
Sets the CC (control change)
Sets the CC number used
Sets the CC number used
Sets the CC number used
Sets the CC number used
Sets the CC number used
Sets which connector is used
Sets which connector is used