Battery Replacement; Setting The Address Of Your Directv Plus™ Digital; Now You Can Turn It On; Satellite Receiver - DirecTV HIRD-E4 Owner's Manual

HUGHES BRAND DIRECTV PLUS™ DIGITAL SATELLITE RECEIVER

Battery Replacement

Your operating range will start to decrease as the battery life decreases. Replacement batteries are
conveniently available at most electronic stores. To replace the battery, follow the directions above.
Remember to dispose of the old battery properly. Use battery type "mn21, 12v" or equivalent.
Setting the Address of your DIRECTV PLUS™ Digital
Satellite Receiver and Remote Control
To avoid interference between your remote control and your neighbors that may have the same model
remote control, you should change the address of your components. This is similar to choosing a
channel on a cordless phone so that you and your neighbors don't hear each others' conversations.
See the chapter, "Programming Your Remote Control" for the instructions to accomplish this.

Now You Can Turn It On

Once you have connected everything, you can begin powering up the components. Turn the TV on and
set it to the digital satellite receiver's output channel (3 or 4) or input (video or S-video). Do the same
for the VCR, if applicable. Now turn the digital satellite receiver on. You will see the start-up screen
for several seconds, followed by a black screen with the message at the bottom:
"Searching for satellite signal. To access related utilities, press ."
If so, this is good! If not, try pressing the key while the remote control is in SAT mode. If that
doesn't work, check all of the connections.
You're well on your way to enjoying your satellite system.
P 2-8
AGE