FujiFilm GW690 2 Factory Service Manual And Parts List page 48

REASSEMBLY AND ADJUSTMENT
FUJI PROFESSIONAL GW69011, GSW69011
3 - 8 Installing the top cover assembly ( 4 - 1) and adjusting the exposure counter
1) Install the top cover assembly (4 - 1) temporarily, load the camera with
a film, set the film selector (3 - 3) to "4EXP", wind up the film advance
lever, and make sure that the ex po sure counter indicates "l ".
Now, depress the shutter release, and make sure that the shutter is released
and the exposure counter advances accordingly. Further, make sure that
the exposure counter no longer advances when the exposure counter
indicates "4".
2) Next, reload the camera with a film, advance the film, and make sure
that:
A)
The shutter cannot be released when the exposure counter is in
between "S" and "l ".
B)
The shutter cannot be released when the exposure counter is in
between "l" and "2", "2" and "3", and "3" and "4".
[The shutter can be released only when the exposure counter indicates
a certain number after advancing the film one frame completely.]
Make the above check with the film selector set to "8EXP" and "16EXP"
also.
3) Remove the top cover assembly, remove one screw (1 - 4), and reinstall
the screw after applying the lug (7 - 40).
Connect the red lead wire ( 3 - 35) to the contact ( 3 - 25) by the use of a
soldering iron.
Next, connect the black lead wire (3 - 36) to the contact (3 - 32) by the
use of a soldering iron.
4) Thoroughly clean the lens of the range finder, viewfinder frame and other
windows on the top cover, blow out dust from the inside, place the rib
(1 - 47) on the chassis, and install the top cover assembly (4 -1) on the
chassis with three screws (1 - 1).
5) Place the shutter release shaft (1 - 20), stopper (1 - 19), film advance
lever (1 - 18) and spring washer (1 - 17) in their positions, and secure
them with the top shutter release assembly (1 - 13).
When tightening the top shutter release assembly (1 - 13), recommend a
piece of thin rubber sheet be used.
-46-