FujiFilm GW690 2 Factory Service Manual And Parts List page 26

REASSEMBLY AND ADJUSTMENT
FUJI PROF ESSIONAL GW69011, GSW6901 I
1 - 8 Assembling the front mask assembly (7 - 84)
1) Apply the front shutter release (7 - 88) to the cover assembly (7 - 68),
and install them on the front mask (7 - 89) with two screws (7 - 96).
Make sure that the shutter release moves smoothly.
2) Apply the pin (7 - 100) of the release lever assembly (7 - 98) beneath the
portion (K) of the lever (7 - 110), and install the guide shaft (7 - 109)
and guide shaft (7 - 106) repectively to the upper and lower sides with the
screw (7 - 107). Make sure that the release lever assembly (7 - 98) operates
by its own weight.
Apply the spring (7 - 108) to the pin (7 - 101) and guide shaft (7 - 109).
3) Install the shutter actuation counter assembly (7 - 93) on the front mask
assembly (7 - 84) with two screws (7 - 90).
NOTE: Be careful not to deform the claw (7 - 105).
Adjust the head of the claw (7 - 105) so that the ratchet wheel (7 - 95)
advances one tooth when the shutter release is depressed o nce and the
last one digit of the exposure counter advances one number when the
shutter release is depressed ten times.
- 24 -