FujiFilm GW690 2 Factory Service Manual And Parts List page 22

REASSEMBLY AND ADJUSTMENT
FUJI PROFESSIONAL GW69011, GSW69011
1 - 2 Installing the shutter frame assembly (7 - 41)
1) Match the hole (B) of the holder (7 - 51) with the groove (C) of the
hold ring (7 - 79), and install the shutter frame assembly (7 - 41) on the
helicoid assembly with three screws (7 - 46).
2) Apply the gear shaft (7 - 124) to the groove (C) of the hold ring (7 - 79)
in the posture shown in Fig. 6, apply the gear (7 - 54) to the gear
shaft, insert the shaft head into the hole (B) of the holder (7 - 51),
apply the shaft holder (7 - 52), and secure it with the E - clip (7 - 53).
1 - 3 Installing the focusing ring (I) (7 - 63) and index ring assembly (7 - 24)
1) Set the helicoid to its infinite position, fit the focusing ring with the
oo
marked faced upward, and install the screw (7 - 64).
Next, install the focusing ring with three set screws ( 7 - 65) tern porarily,
set it in the position where the stopper stops at the infinite and close - up
distances.
NOTE: Head of the set screw (7 - 65) must come into contact with the
slope on the ring (7 - 78).
2) Install the index ring assembly (7 - 24) with three screws (7 - 46), make
sure that the moquette (7 - 208) is not damaged and installed on the
index ring correctly, and then, screw the focusing ring (II) (7 - 61) into
the focusing ring (I) (7 - 63).
1 - 4 Installing the hood (7 - 203) and protector ring (7 - 201)
Fit the hood (7 - 203) to the protector ring (7 - 201 ), and with the index
window (7 - 202) faced upward, install them with two screws (7 - 207)
together with the stopper ring (7 - 206).
Make sure that the hood comes in and out smoothly.
-20-