FujiFilm GW690 2 Factory Service Manual And Parts List page 36

REASSEMBLY AND ADJUSTMENT
FUJI PROFESSIONAL GW69011, GSW69011
2 - 2 Assembling the exposure counter assembly
1) Apply the gear (4 - 80) to the gear shaft (4 - 82) of the rotary plate
assembly (4 - 77), and secure it with the E - clip (4 - 85).
2) Apply the spring ( 4 - 101) to two stopper pins ( 4 - 104), insert the rotary
plate assembly ( 4 - 77) in between the counter gear ( 4 - 97) of the dial
assembly ( 4 - 93) and disc ( 4 - 99), apply both of them to the shaft holder
( 4 - 102) and shaft ( 4 - 103), and push them into the deepest position with
the return lever ( 4 - 39) fully pushed in.
Thus, the rotary plate, lever assembly ( 4 - 88) and return lever ( 4 - 39) can
be correctly positioned.
3) Wind up the spring ( 4 - 101) one turn, and secure the dial assembly ( 4 - 93)
with the screw ( 4 - 92).
Next, apply the gear assembly ( 4 - 60) to the shaft holder ( 4 - 102) from
the bottom, and install the gear ( 4 - 7 6) and nut ( 4 - 7 5 ). Now, lock the
nut on the shaft with screw locking agent.
Apply the smaller hook and larger hook of the spring ( 4 - 81) respectively
to the hole on the lever and guide shaft ( 4 - 44).
2 - 3 Combining the ratchet wheel assembly ( 4 - 67) with the film take - up gear
grain
1) Apply the spring ( 4 - 5) to the pin ( 4 - 8) of the sleeve ( 4 - 7), and passing
through the inside of the column ( 4 - 24 ), apply the other end of the
spring ( 4 - 5) to the guide shaft ( 4 - 44).
2) Place the base plate ( 4 - 3) in its position, turn the sleeve ( 4 - 7) toward
the film taking up direction, and tighten four screws (4 - 2) when the
projection on the sleeve enters the square portion of the base plate ( 4 - 3).
3) Match the cut portion of the ratchet (for charging the shutter) with the
square hole of the arm ( 4 - 29) accurately (evenly), fit the gear ( 4 - 42)
to the shaft ( 4 - 68) without deviating the above matching, and after
applying the washer ( 4 - 43) to the screw ( 4 - 40), install the gear ( 4 - 42)
with the screw ( 4 - 40).
4) Install the dial ( 4 - 95) on the gear with two screws ( 4 - 94) and gear
( 4 - 109). Make sure that each gear operates smoothly, each lever
operates smoothly each spring is installed correctly, each lever is not
deformed, and that each screw is tightened securely.
-34-