Troubleshooting - Kernau KFD 801 W Manual

Your dryer is fitted with systems that continuously perform checks during the drying process to
take the necessary measures and warn you in case of any malfunction.
WARNING: If the problem persists even if you have applied the steps in this section, please
contact the your dealer or an Authorised Service Provider. Never try to repair a nonfunctional
product.
PROBLEM
The drying process takes a
long time.
Laundry comes out damp
at the end of the drying
process.
The dryer cannot be
opened or the programme
cannot be started. The
dryer does not get activated
when adjusted.

7. TROUBLESHOOTING

REASON
The surface of the lint filter might be
clogged.
The heat exchanger might be
clogged.
The ventilation grills in front of the
machine might be closed.
There might be a layer of limescale
on the humidity sensor.
The dryer might be overloaded with
laundry.
The laundry might be insufficiently
spun.
The laundry that comes out hot at the end of the drying process
The programme used might not be
suitable for the type of laundry.
The surface of the lint filter might be
clogged.
The heat exchanger might be
clogged.
The dryer might be overloaded with
laundry.
The laundry might be insufficiently
spun.
The dryer might not be plugged in.
The loading door might be open.
You might not have set a programme
or pressed the Start/Pause key.
Child lock might be active.
Wash the filter with lukewarm water.
Wash the heat exchanger
Open the doors/windows to prevent
the room temperature from rising too
Clean the humidity sensor.
Do not overload the dryer.
Select a higher spin speed on your
generally feels more humid.
Check the care labels on the laundry
items, select a suitable programme for
the type of laundry and additionally,
use the time programmes.
Wash the filter with lukewarm water.
Wash the heat exchanger
Do not overload the dryer.
Select a higher spin speed on your
Make sure that the plug is fitted in the
Make sure that the loading door is
Make sure that the programme has
been set and the dryer is not in the
Standby (Pause) mode.
Deactivate the child lock.
EN
SOLUTION
much.
washing machine.
washing machine.
socket.
properly closed.
64