Delta 9000 BTU User Manual page 11

REMOTE CONTROL
COOLING MODE
The cooling function allows the air
COOL
conditioner to cool the room and
reduce Air humidity at the same
time.
To activate the cooling function (COOL), press the
MODE button until the symbol
the display.
With the button or
than that of the room.
FAN MODE (Not FAN button)
Fan mode, air ventilation only.
FAN
To set the FAN mode, press MODE until
appears on the display.
DRY MODE
This function reduces the humidity
DRY
of the air to make the room more
comfortable.
To set the DRY mode, Press MODE until
appears in the display. An automatic function of
pre-setting is activated.
AUTO MODE
Automatic mode.
AUTO
To set the AUTO mode, press MODE until
appears on the display.
In AUTO mode the run mode will be set
automatically according to the room temperature.
appears on
set a temperature lower
HEATING MODE
The heating function allows the air
HEAT
conditioner to heat the room.
To activate the heating function (HEAT), press the
MODE button until the symbol
display.
With the button
than that of the room.
In HEATING operation, the appliance can
automatically activate a defrost cycle, which
is essential to clean the frost on the condenser
so as to recover its heat exchange function.
This procedure usually lasts for 2-10 minutes.
During defrosting, indoor unit fan stop
operation. After defrosting, it resumes to
HEATING mode automatically.
(For North American market)
If necessary, you can press ECO button 10
times within 8 seconds under heating mode
to start the forced defrosting. It will defrost
the outdoor ice much more fast.
FAN SPEED function (FAN button)
Change the operating fan speed.
FAN
Press FAN button to set the running fan speed,
it can be set to AUTO/ MUTE/ LOW/ LOW-MID
/ MID/ MID-HIGH/ HIGH/ TURBO speed circularly.
(Flash)
Child-Lock function
1. Long press MODE and TIMER button together
to active this function, and do it again to
deactivate this function.
2. Under this function, no single button will active.
9
appears on the
or set a temperature higher