Technical Data - Goddess RSD 084 GW8SSF Instruction Manual

Problem
Appliance does not
work
The food is too warm.
Appliance cools too
much
Unusual noises
Water on the floor
Side panel is hot
If the malfunction shows again, contact the Service Center.
VII. TECHNICAL DATA
à Technical information can be found on the type plate inside the appliance
(or on its back side) and on the energy label.
à "Information Sheet" and "Directions for Use" can be downloaded at: www.goddess.cz.
à QR code on the energy label supplied with the appliance provides a web link to
information concerning the specification of this appliance in the EU EPREL database.
à Keep the energy label together with user manual and all other documentation supplied
with this appliance.
à The same information in the EPREL database can also be found at:
https: //eprel.ec.europa.eu
à The model name (product number) can be found on the type plate of the appliance
and also on the energy label supplied with the appliance.
à We reserve the right to change technical specifications.
Possible cause
Temperature regulation knob is
set at number "0".
Mains plug is not plugged in or
is loose
Fuse has blown or is defective
Socket is defective
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Temperature is set too cold.
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
Water drain hole is blocked.
Condenser is inside the panel.
EN - 53
Solution
Set the knob at other number
to switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to be
corrected by an electrician.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature
regulation to a colder setting
temporarily.
Please look in the installation
location section.
Turn the temperature
regulation knob to a warmer
setting temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
See the Cleaning section.
It's normal.
EN