Repair And Maintenance - Razor vector Owner's Manual

USAGE
Changing the Speed Mode
There are two modes for speed. The Vector is set on the Low (12.5 mph (20 km/h)) speed setting at the factory.
Press power button twice quickly to select the speed mode. This icon shows the Low speed mode in white and the
Sport speed mode in red.
1
The Low mode max speed is up
to 12.5 mph (20 km/h).

REPAIR AND MAINTENANCE

Turn power switch "OFF" before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power off
Front Wheel Replacement
Required Tools: Two (2) 5 mm Allen Wrenches (one wrench included)
1
Using two (2) 5 mm Allen wrenches, loosen the axle bolt. Remove the
wheel. Note the sequence of the hardware.
White
2
The Sport mode max speed is
up to 18 mph (29 km/h) as shown by
an "S" at the top of the display.
• Secure the product under repair
• Exercise caution around
exposed parts
Red
• Contact Razor customer service
if unsure about any repair or
maintenance
• Repair and maintenance should
be performed by an adult only
2
Install the replacement wheel
and tighten the axle bolt.
8 8
Note: The Vector display default
setting is in miles. If you would like
to change the display setting to
kilometers, press the power button
(A) three times quickly to select the
kilometers setting.