Download Print this page

Razor VECTOR Manual

Handlebar kit replacement procedures

Hide thumbs Also See for VECTOR:

Download this manual

Required Tools: (Not included)

A. Phillips screwdriver

B. Long needle pliers

C. 5 mm Allen wrench

WARNING

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these

steps in the correct order may cause irreparable damage.

Step 1

Using a Phillips screwdriver, remove two (2) screws from

the battery cover on the right side of the unit.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.

VECTOR HANDLEBAR KIT

REPLACEMENT PROCEDURES

Step 2

Locate and disconnect the throttle and brake lever

connectors from the controller.

PART # W15110710027

Need help?

Do you have a question about the VECTOR and is the answer not in the manual?

Page 1 Locate and disconnect the throttle and brake lever the battery cover on the right side of the unit. connectors from the controller. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Page 2 Step 7 Reverse the steps. ATTENTION: Charge battery 8 hours before using. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.