Advertisement
Warning! - Remove any cables attached to the Fault Trapper™ before opening battery compartment!
Changing Battery
1) Remove screw on rear of unit near the middle with a #1 Philips head screwdriver.
2) Remove battery and disconnect from battery snaps.
3) Attach a new 9 volt alkaline battery to the battery snaps and return to battery compartment.
4) Place battery cover in slot and rotate shut. Fasten shut with screw removed. Do not over tighten!
Specifications
Physical Dimensions
Fault Trapper Main Unit
Size: 15.25 x 7.6 x 3.8 cm (6.0 x 3.0 x 1.5 inches)
Weight: 255 grams (9 oz.) With battery
40amp In-Line Adapter
Size: 11.5 x 7.6 x 5.85 cm (4.5 x 3.0 x 2.3 inches)
Weight: 312 grams (11 oz.)
Input Rating:
Fault Trapper Main Unit: 90 to 265 Volts ac rms 50/60 Hz, 4 watts max.
40amp In-Line Adapter: 300 Volts ac rms, 40 amp circuits maximum, supplies power to main unit
Measurement Method: Spread Spectrum Time Domain Reflectometry (SSTDR)
Accuracy: +/-10%
Maximum Length: 300 ft on NM-B or Wire in Conduit
Battery is used to review results when not AC powered
Battery Low Level: Approximately 5.5 volts
Battery Life (9 Volt alkaline battery, typical) - Standby: 2 years
Environmental
Temperature -
Operating: 0° to 50°C (32° to 122°F)
Storage temperature: -20° to 60°C (-4° to 140°F)
Long Term Storage w/ battery: 35°C maximum (95°F)
Humidity: 10% to 90%, non-condensing
Altitude: 2,000 meters (6,561ft) maximum
Toll Free: 800-749-5783
Fault Trapper™
Transient Fault Location for Branch Circuit Breakers
Active: 4 hours typical
Page 8 of 8
V 1.3 (draft)
Advertisement
