Servicing/Maintenance; Simulator Charging; Battery Replacement - FGD FlameSpec User Manual

FlameSpec Flame Simulator Manual

4 Servicing/Maintenance

Warnings:
• Do not try to open, modify or repair the Flame Simulator.
• Repair, inspection or maintenance of this equipment should be performed by
suitable trained personnel, in accordance with the applicable code of practice,
e.g. EN 60079-19. Operation must be in accordance with recognized standards
of the appropriate authority in the country concerned.
• Charge battery in a safe area– Battery chamber should only be opened in a non-
hazardous location.
1. Periodically, the flame simulators front window should be cleaned using a soft cloth,
water and a mild detergent. Clean and dry window.
2. Always make sure the flame simulator battery is fully charged prior to use.
3. To maintain the battery life, it should be fully charged at least once in a 3-month
period.
4. Replace battery only with part number FLS-FSIM-BATT

4.1 Simulator charging

Charge battery in a safe area – Battery chamber should only be opened in a non-
hazardous location.
1. Release the locking screw using the Allen key
2. Using strap wrench tool to remove the back-battery cover (2) of simulator by
unscrewing
3. Connect supplied charger to charging jack (8) and connect charger to power supply,
110-220VAC.
4. Allow to charge for at least 3 hours until the green LED on the charger is seen
5. Disconnect charger, close back-battery cover (2) and tighten using the removal tool.
6. Close the locking screw using the Allen key.

4.2 Battery replacement

Battery replacement in a safe area– Battery chamber should only be opened in a
non-hazardous location.
1. Release the locking screw using the Allen key
2. Using strap wrench tool to remove the back-battery cover (2) of simulator by
unscrewing.
3. Disconnect the battery connector from the PCB
4. Remove the Battery by pulling it out from the holder
5. Put a new Battery in place and connect the connector
For more information & technical support: (+1) 714-671-8500 · support@fg-detection.com
Doc. No. F300V0020.01
4