Stanley ST-02-230-E Instruction Manual page 142

NEVER LEAVE HEATER UNATTENDED WHILE
CONNECTED TO A POWER
Assembly (See Page 7)
1. ASSEMBLE TOP HANDLE BRACKET (Fig.
1)
i. Slide upper handle brackets onto front
handle and align holes.
ii. Slide rear handle into upper handle
brackets and align holes.
2. INSTALL HEATER LEG FRAME (Fig. 2)
i. Align lower inner bracket with holes in
heater.
ii. Attach aligned holes in Heater leg
frame with lower inner bracket.
iii. Align lower outer bracket holes with
lower inner bracket, and attach using 2
bottom screws.
3. INSTALL SIDE SUPPORTS (Fig. 3)
i. Slide side support into lower bracket
and align holes.
ii. Attach using top remaining screw.
4. INSTALL TOP HANDLE BRACKET (Fig. 4)
i. Slide side support into upper bracket
and align holes.
ii. Attach upper brackets to heater using 3
screws per side.
Operation
1. Position the fan heater so that it stands
upright on a firm, level surface and at
a safe distance from wet environments
and flammable objects.
2. Connect the fan heater to the proper
electrical power.
3. Set the thermostat dial to the maximum
temperature.
4. The fan heater will switch on when the
function selector dial is set to one of the
power settings.
5. Once the room reaches the desired
temperature, turn the thermostat dial
back until heating element turns off.
Automatic Overheat Safety Control
–
This heater is equipped with safety
internal heat limiting thermostat and
overheat protection circuit. When a
potential overheat temperature is
© 2021, Obelis S.A. Registered Address:
Bd. Général Wahis, 53, 1030 Brussels, Belgium
SOURCE
reached, the system will automatically
shut the heater off
Thermostat Instructions
–
At first, set the thermostat to "+" and
let the heater operate with full power
input. When the room temperature
reaches the required value, turn the
thermostat to the left until it switches
off.
–
The thermostat will then switch on
and off automatically to control the
room temperature according to the
preset value and keep the room
temperature constant.
–
When using the heater for the first
time, you may notice a slight emission
of smoke. This is quite normal and it
stops after a short time. The heating
element is made of steel and was
coated with a layer of protective
oil during production. The smoke
is caused by the leftover oil as it is
heated.
Cleaning and Maintenance
–
Before cleaning the appliance,
disconnect it from the outlet and let it
cool down.
–
The enclosure is easy to get dirty.
Wipe it often with a soft sponge.
For very dirty parts, wipe with a
sponge dipped in < 50°C water and
mild detergent, then dry the heater
enclosure with a clean cloth. Be
careful not to let the water enter the
inside of the appliance
–
In order to protect the enclosure,
don't splash water onto the heater,
and never use a solvent like gasoline,
isoamyl acetate, toluene, etc. to clean
the heater.
–
When you store the heater, let it cool
down first and, keep it dry. Then
cover it with a plastic bag, put it in
the packing box and store it in a dry,
ventilated place.
10