Get Started; Connect The Docking Station; Install The Recorder; Insert And Eject The Memory Card - Philips POCKET MEMO Manual

3 Get started

Caution
• Ensure you have read the safety instructions before you
connect and install your recorder.  Safety instructions, p.
5.

Connect the docking station

1
Plug the USB connector into a USB port on your computer.
2
Insert the micro USB plug into the USB port on the rear side
of the docking station.

Install the recorder

Note
• Charge the battery for 3 hours before first use.
The battery is pre-installed in the recorder. Pull the battery tape
off from the battery door before charging.

Insert and eject the memory card

The device operates with a SD/SDHC memory card and
supports cards with storage capacities of up to 32 GB. Your
recorder is packaged with a memory card already inserted and
formatted.
To insert and eject a memory card:
1
Locate the memory card slot on the top of the recorder.
2
Insert a memory card with the gold-colored contacts facing
down (toward front of the device).
3
Push the memory card in the memory card slot until it locks
in place.
4
To remove the card press the memory card slightly until the
snapping mechanism unlocks and the card is ejected.
11
EN