3 Get started
• Ensure you have read the safety instructions before you
connect and install your recorder. Safety instructions,
Connect the docking station
Plug the USB connector into a USB port on your computer.
Insert the micro USB plug into the USB port on the rear side
of the docking station.
Install the recorder
• Charge the battery for 3 hours before first use.
The battery is pre-installed in the recorder. Pull the battery tape
off from the battery door before charging.
Insert and eject the memory card
The device operates with a SD/SDHC memory card and
supports cards with storage capacities of up to 32 GB. Your
recorder is packaged with a memory card already inserted and
To insert and eject a memory card:
Locate the memory card slot on the top of the recorder.
Insert a memory card with the gold-colored contacts facing
down (toward front of the device).
Push the memory card in the memory card slot until it locks
To remove the card press the memory card slightly until the
snapping mechanism unlocks and the card is ejected.