Operation; Product View And Parts Identification; Blade Control; Cutting Height Adjustment Lever - Craftsman C459-36310 Operator's Manual

Recoil Starter
Grass Catcher
Side Discharge

Blade Control

The blade control is attached to the upper handle of the mower. Depress and
squeeze it against the upper handle to operate the unit. Release it to stop engine
and blade.
This blade control is a safety device. Never attempt to bypass its operation.

Cutting Height Adjustment Lever

One adjustment lever is located on the right rear wheel and one is located on the
right front wheel. Both levers have to be at the same position to ensure a uniform
cut. To adjust the cutting height, refer to the Assembly Section.
Deck Wash
Your mower's deck is equipped with a water port on its surface as part of its deck
wash system. Use the deck wash to rinse grass clippings from the deck's underside.
Mulch Cover
The mulch cover is used to recirculate grass clippings back to the lawn. Attach it as
instructed in the Assembly section of this manual.
Cutting Height
Adjustment
Lever
Cover
WARNING

OPERATION

Blade Control
Gas Cap
Oil Fill Cap
Oil Drain
Mulch Cover
Figure 12
Side Discharge Cover
Your mower is shipped as a mulcher. To discharge the grass clippings to the side
instead, follow the instructions in the Assembly section to attach the side discharge
cover.
Keep hands and feet away from the chute area on cutting deck. Refer to
warning label on the unit.
Trail Shield
The trail shield is attached to the rear of the mower and is there to protect the
operator from flying debris. Do not use the mower unless the shield is fully
functional and in place.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand behind the unit and
pull the recoil starter rope to start the unit.
Oil Fill Cap/Dipstick
Refer to the Maintenance section for instructions on checking the oil.
11
Deck Wash
Air Cleaner
Cutting Height
Adjustment
Lever
WARNING