Operating Instructions - Kobalt KDD 524B-03 Manual

OPERATING INSTRUCTIONS

1. Battery Pack
To Attach Battery Pack
a. Place the direction-of-rotation selector (E) in the
center lock position.
b. Align the raised portion on the battery pack with the
grooves on the bottom of the tool, then slide the
battery pack onto the tool as shown.
c. Make sure that the latch on the battery pack snaps
into place and the battery pack is secured to the tool
before beginning operation.
NOTICE: When placing the battery pack on the tool,
be sure that the raised rib on battery pack aligns with
the groove on the tool and the latches snap into place
properly. Improper assembly of the battery pack can
cause damage to internal components.
To Detach Battery Pack
a. Place the direction-of-rotation selector (E) in the
center lock position.
b. Press the battery-release buttons to release the
battery pack.
c. Pull forward on the battery pack to remove it from the
tool.
WARNING
• Battery tools are always in operating condition.
Therefore, the direction-of-rotation selector (E) should
always be locked (center) when the tool is not in use or
when carrying the tool at your side.
2. Variable-speed Trigger Switch
a. To turn the drill/driver ON, depress the trigger
switch (D).
b. To turn it OFF, release the trigger switch.
Variable Speed
The variable-speed trigger switch delivers higher
speed with increased trigger pressure and lower
speed with decreased trigger pressure.
Electric Brake
The drill/driver is equipped with an electric brake.
When the trigger switch is released, the electric
brake engages automatically to quickly stop
rotation.
1a
E
1b
E
2
D
8