Cleaning, Maintenance And Troubleshooting - Carrier 40MBDQ Owner's Manua

CLEANING, MAINTENANCE AND TROUBLESHOOTING

CAUTION
ELECTRICAL SHOCK HAZARD
Failure to follow this caution may result in personal injury or death.
Always turn off power to the system before performing any cleaning
or maintenance to the system. Turn off the outdoor disconnect switch
located near outdoor unit. Be sure to disconnect the indoor unit if on a
separate switch.
CAUTION
EQUIPMENT DAMAGE/OPERATION HAZARD
Failure to follow this caution may result in equipment damage or
improper unit operation.
Operating the system with dirty air filters may damage the indoor
unit and could cause reduced cooling performance, intermittent
system operation, frost build-up on indoor coil or blown fuses.
Periodic Maintenance
Periodic maintenance is recommended to ensure proper operation of
the unit. Recommended maintenance intervals may vary depending on
the installation environment, e.g., dusty zones, etc. Refer to Table 2 on
page 11.
CAUTION
CUT HAZARD
Failure to follow this caution may result in personal injury. The coil
fins are very sharp. Use caution when cleaning.
Always wear safety protection.
Cleaning the Coil
Clean the coil at the beginning of each cooling season, or when
necessary. Use a vacuum cleaner or a long-bristle brush to avoid
damage to the coil fins.
Cleaning the Air Filters
Remove and clean the air filters once a month. A clogged air
conditioner can reduce the cooling efficiency of your unit, and can
also be bad for your health.
NOTE: If air filters show signs of excessive wear or are torn, they
must be replaced. Contact your local dealer for replacement filters.
1. Unscrew filters from the frame.
2. Pull filters down to remove.
10
3. Vacuum the filters.
4. Clean with warm water.
5. Shake filter to remove excess water and dry thoroughly.
6. Replace filter by sliding into rack until filter snaps in place.
7. Close front panel on unit.
EQUIPMENT DAMAGE HAZARD
Failure to follow this caution may result in equipment damage. When
cleaning the front panel, do not use water hotter than 105°F (40.6°C)
and do not pour water onto the fan coil.
Do not use abrasive or petroleum based cleaners as they may damage
the front panel.
Specifications subject to change without notice.
Fig. 14 — Remove the Filters
Fig. 15 — Vacuum the filters
Fig. 16 — Clean Filter with Warm Water
CAUTION
OG-40MBDQ-04