Pnp/Pci Configurations - Shuttle MN31 User Manual

@

PnP/PCI Configurations

This category configures how PnP and PCI operate in your system.
Correctly setting up the IRQ and DMA (both PnP and PCI use) assign-
ments will make your system work stably. It is strongly recommended
that only technical users make changes to the default settings.
Reset Configuration Data
When enabled, any PnP configuration data stored in the BIOS will be
cleared from memory, with new data created.
Ø The choice: Enabled or Disabled.
Resources Controlled By
As stays auto(ESCD), the system will dynamically allocate resources to
PnP devices as they are required. As set to manual, the following item
become available.
Ø The choice: Auto(ESCD) or Manual.
IRQ Resources
When the previous item is set to manual, this item allows you respec-
tively assign an interruptive type for IRQ-3, 4, 5, 7, 9, 10, 11, 12, 14,
and 15.
Ø The choice: PCI Device or Reserved.
PCI/VGA Palette Snoop
The item is designed to solve problems caused by some non-standard
VGA cards. A built-in VGA system does not need this function.
Ø The choice: Enabled or Disabled.
INT Pin 1~4 Assignment
Names the interrupt request(IRQ) line assigned to a device connected to
the PCI interface on your system.
Ø The Choice: Auto, 3, 4, 5, 7, 9, 10, 11, 12, 14, or 15.
- 62 -