Synology NAS RS3621xs+ Hardware Installation Manual page 16

Table of Contents

Advertisement

To remove the RAM Module
1 Follow step 1 and 2 of the "To install the RAM module" section to shut down your RS3621xs+, disconnect the
cables, and then remove the rear top cover as described above.
2 Cut the cable tie before removing the memory module. (The pre-installed memory module is cable-tied to
prevent it from loosening during delivery.)
Note:
Avoid touching any components on the motherboard when cutting the cable tie.
3 Push the retaining clips on the slot out to the sides. The memory module will pop out of the slot.
4 Follow step 5 of the "To install the RAM module" section to fasted the top cover back in place.
16 Chapter 2: Hardware Setup

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents