Remote engine starter with alarm system (21 pages)
Summary of Contents for Voxx Electronics Prestige PE1BTWZ
Page 1
Owner’s Guide For Model: PE1BTWZ Flashlogic FLRS RF Upgrade Kit IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply.
Page 2
Table of Contents Using Your Remote Control ............3 2 Way Remote Control Notifications .........4 Remote Start Valet Mode ............5 Remote Control Programming ...........5 Replacing Remote Control Batteries ........6 2018 Voxx Electronics Corporation. All rights reserved.
Using Your Remote Control Door Lock To lock the vehicle doors press and release the button. Door Unlock To unlock the vehicle doors press and release the button 2 times. Remote Starting Your Vehicle To activate the remote start, press and hold the button for 3 seconds.
Page 4
2 Beeps / Flashes Remote Start Activation RS Activation Melody Confirm Remote Start 4 Beeps / Flashes Remote Start Running 1 Flash per 5 seconds for duration run time Remote Start Shutdown RS Shutdown Melody 2018 Voxx Electronics Corporation. All rights reserved.
Remote Start Valet Mode Enter / Exit Valet mode for systems using an Flashlogic FLRS kit. Cycle ignition ON five times [5x OFF/ON] rapidly. (complete this step within 7 seconds) Wait, LED 1 (on the FLRS kit) will turn solid RED for 2 seconds. Turn ignition to OFF position.
Page 6
Using a coin, unsnap and disassemble the halves of the remote control. Remove the old battery, observing the +/- symbols on the battery and replace with new battery. Reassemble the halves of the remote control. Test operation of the remote control. 2018 Voxx Electronics Corporation. All rights reserved.
Page 7
Voxx Electronics Corporation. Customer Service 1-800-225-6074 www.PrestigeCarSecurity.com FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.
Need help?
Do you have a question about the Prestige PE1BTWZ and is the answer not in the manual?
Questions and answers