olympia electronics BS-531/1 Manual

ΒS-531/1
OPERATION VOLTAGE
MAXIMUM CONSUMPTION
MAXIMUM SOUND OUTPUT in1m
BEACON
ΤYPE OF APPLICATION ENVIRONMENT
MOUNTING
COVERAGE (y)
MOUNTING HEIGHT (x)
COVERAGE VOLUME CODE
COVERAGE VOLUME
FLASH RATE
FLASH COLOUR
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIAL
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
GENERAL
This device is Visual Alarm Devices (VAD)
for fire detection panels that offer a strong
sound output and an optical warning with a
beacon. The strong sound and the optical
warning beacon cover many square metres.
It features two inputs (N1, N2) for the
production of two different sounds.
device can co-operate with any fire detection
panel (BSR-2104, BSR-2114, BS-1632, BS-
1634, BS-1636, BS-636).

Installation and Connection

1. First, remove the retaining screw, place a
flat blade screwdriver in the holes of the
plastic hooks and remove the plastic cover
(Image 1 on page 2).
2. Remove carefully the beacon connector
(Image 2 on page 2).
3. Use the supplied mounting parts to install
the siren's base at a height of 2.4 metres
from the floor (figure 1 on page 2). Place the
plastic plugs and fasten the screws to the
mounting holes. Attention!! Make sure that the
siren's base is installed upwards as shown in
figure on page 4.
4. Place the caps and make a hole in the
center using a small screwdriver. Pass
Page 1 from 5
SOUNDER WITH BEACON FOR FIRE DETECTION PANEL
ΤΕCHNICAL CHARACTERISTICS
Thank you for your trust in our products
Olympia Electronics - European manufacturer
21-28V DC
94dB (sound effect 1)
1 Power LED
6 m around the siren at an angle of 180°
86.4m³ (max)
1 Hz (Switchable to 0.5 Hz)
EN 54-3: 2001 +Α1:2002 +Α2:2006, EN 54-23: 2010
Bayblend FR3010, transparent polycarbonate
141 x 141 x 100 mm
through the caps the cables to connect the
device.
5. The (+N1 or the +N2) terminal block is
connected to the (+) output of Alarm-1 or
Alarm-2 of the panel and the (-) of the
terminal block is connected to the (-) output of
Alarm-1 or Alarm-2 of the panel. Accordingly
This connect in parallel all the sirens. (The
maximum number of sirens depends on the
type of the panel).
6. To select various sound effects use the
dipswitch 1, 2 and 3 and choose the diserable
sound effect, according to tables 2 and 3 on
page 3.
7. For LED effect variation use the dipswitch
4 (Table 1) on page 2. On the last siren of the
line, we must connect in parallel with its power
cables, the terminal resistor that was removed
from the alarm contacts of the panel.
8. Reinstall the beacon connector (step 2).
Refit the plastic cover until the plastic hooks
are securely attached (step 1) and fasten the
retaining screw (torque 0.6Nm). Attention!!
Make sure that the siren's cover is installed in
the correct orientation.
9. Test the device after installation.
1.2W
Τype Α
Wall
2.4m max
W-2.4-6
Red
IP42C
o
0 to 60 C
Up to 95%
230gr.
2 years
921531007_09_008