Table of Contents
Advertisement
Pressure/Water Requirements
We recommend a BAR pressure between 2.5 and 3.4 BAR. If
you have a combi boiler system no problem should be
experienced. If you have a gravity feed older type installation
(hot water tank type usually less than 1 BAR) you will almost
certainly need a pump. We cannot advise on which type of
pump is used, location or design because all house plumbing
layouts vary. This is a job for your installer/plumber. The end
delivery however must fall within the scope above.
Important Note Do not exceed 3.4 BAR pressure under any
circumstances. Warranty is void if so as damage will occur. If
you have a combi supply, please use a pressure reducing valve
if required to lower the BAR pressure to the shower.
Please Remember that this product is free standing and is
designed to be pulled away from the wall.
The waste hose must be of a flexible type
supplied).
The water supply pipes must be that of a flexible braided type
(not supplied).
DO NOT OVERTIGHTEN THE BRAIDED HOSES AS IT CAN CAUSE
THE CONNECTION TO POP AFTER A FEW WEEKS OF USE.
Always fit easy to get to isolation taps on both hot and cold
water supply (not supplied). Just like a dishwasher or washing
machine, this product MUST be isolated when not in use.
www.insigniashowers.com
•
Scissors
•
Knife
•
Spirit Level
•
Tape Measure
•
RubberGum (supplied)
•
Plumbers Mait (not supplied)
•
Hot and cold isolation valves (not supplied)
•
2x Braided hoses (not supplied) Steam version
(1m flexible waste
requires 3. If you haven't purchased these already,
simply click the following link below or copy in to
any web browser. For ease we have listed the
required pack below for your install.
•
Shower cabins require pack 1
https://www.insigniashowers.com/wras-approved-
braided-hoses.html
Tools Required
You will require:
•
Philips Screwdriver
•
Electric Drill
•
Safety Gloves
•
Safety Glasses
Parts Required
Last Modified: 10/02/2021
06
Advertisement
Table of Contents
