Table C-3. Microprocessor Module Jumper Settings - Dell 6100 Installation And Troubleshooting Manual
Dell poweredge 6100 servers: install guide
Hide thumbs
Also See for 6100:
- User manual (130 pages) ,
- Service manual (97 pages) ,
- Hardware manual (15 pages)
Table of Contents
Advertisement
See Table C-3 for the microprocessor module jumper
settings.
Jumper
J101
J105
J106
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviation and acronym list.
jumpered
Table C-3. Microprocessor Module Jumper Settings
Setting
unjumpered
Description
(default)
A processor is not installed in the adjacent slot.
This jumper is useful only when you are using ITP.
A processor is installed in the adjacent slot.
(default)
A 200/66 MHz microprocessor is installed.
(default)
A processor is not installed in the adjacent slot.
This jumper is useful only when you are using ITP.
A processor is installed in the adjacent slot.
Jumpers, Switches, and Connectors
C-7
Advertisement
Table of Contents
Troubleshooting
