Making Selections In The Eisa Configuration Utility; Using Online Instructions; Starting The Eisa Configuration Utility - Dell PowerEdge 4200 Series User Manual

Making Selections in the EISA Configu-
ration Utility
The EISA Configuration Utility uses menus to guide you
through the configuration process. The menus and their
options are accessed through keyboard commands.
To make a menu selection, use the up- or down-arrow key
to highlight the desired option, and then press <Enter>. In
the Help menu or Advanced menu, you can also select an
option by pressing the key that corresponds to the high-
lighted letter in the selection list.
To scroll up or down a screen, press the <Page Up> or
<Page Down> key, respectively.

Using Online Instructions

The EISA Configuration Utility has online instructions
for each of its procedures. If you need help at any time,
press <F1> to see a help screen that offers more details
about the task you are doing.
S
tarting the EISA Configuration
Utility
NOTE: Your system's default hardware configuration
allows updating of the EISA configuration information.
However, if the EISA jumper on the system board is
installed, the EISA configuration information cannot be
updated until the jumper plug is removed.
If you have reason to think the EISA jumper setting has
been changed, have a technician check the jumper before
attempting to make an EISA configuration change. For
information on the EISA jumper location and settings,
see Figure C-1 and Table C-1, respectively, in the Installa-
tion and Troubleshooting Guide.
If you are running the EISA Configuration Utility from
your hard-disk drive, remove any terminate-and-stay-
resident (TSR) programs from memory before starting
the utility. These programs take up space in system mem-
ory even when they are not running, thus reducing the
amount of memory available to the EISA Configuration
Utility. See the documentation that accompanied these
programs for instructions on removing them from
memory.
If you start the utility and there is not enough memory to
run it, a message is displayed. If you receive such a mes-
sage, run the utility from a diskette.
Follow these steps the first time you use the EISA Con-
figuration Utility. Later, if a card is added, removed, or
repositioned, you must follow the procedure described in
"Step 2: Add or Remove Boards" found later in this
chapter.
1. To run the program from a diskette, insert into
drive A the EISA Configuration Utility diskette
that you created from the CD. Then either turn
on your computer or reboot it by pressing the
<Ctrl><Alt><Del> key combination or the reset
button.
To run the program from your hard-disk drive, switch
to the c:\eisacfg subdirectory, type sd at the operat-
ing system prompt, and press <Enter>.
To run the program from the Dell Server Assistant
CD, restart the system from the CD. Select Run
EISA Configuration Utility from the CD's main
menu.
To access the advanced options (described in
"Advanced Menu" found later in this chapter), press
<Ctrl><a> at the Welcome screen.
You can run the EISA Configuration Utility in mod-
eling mode by typing sd /n at the operating system
prompt and pressing <Enter>.
NOTE: To use modeling mode, you must run the
EISA Configuration Utility from your hard-disk
drive.
Modeling mode lets you set up configuration param-
eters for a system different from the one you are
using and allows you to save a configuration to a
file. Modeling mode is useful if you need to config-
ure many systems identically; instead of using the
EISA Configuration Utility to configure each sys-
tem, you can transfer the configuration file to a
diskette and load it onto each system. See "Modeling
Mode" found later in this chapter for more
information.
Press <Esc> to return to the Welcome screen.
Using the EISA Configuration Utility 5-3