Melec GD-5510 -01 Instruction Manual page 33

１０－２．Conforming to Europe standards and UL standards
This product declares the CE Marking(Low voltage directive, EMC directive)
based on the EN standard by oneself.
(1) Safety standards
EN50178
UL508C
●Low voltage directive
This product is designed for use as a built-in component.
・Install the product within an enclosure in order to avoid contact with the hand.
・Securely ground the protective earth terminals.
●Installation conditions
Protective class:
Overvoltage category:
Pollution degree:
Protective type:
arning for L standards
*1
This product has no provision for motor over temperature protection.
Motor over temperature protection is required in the end use product.
(2) EMC standards
EN 61000-6-2
EN 61000-6-4
EN 55011 Group 1 Class A
●EMC derective
This product conducted EMC measurement with the system configuration for EMC.
・EMC characteristic may vary depending on the configuration of the equipment that
contains the driver or stepping motor. Be sure to conduct EMC measurement with
the product assembled in your equipment.
Configuration
The metallic enclosure and shielded wires and ferrite core work to shield noise.
*1
EN50178
Ⅰ
Ⅱ
Class 2
IP-00
UL508C
Ⅰ
Ⅲ
Class 2
IP-00
-33-
GD-5510-01
Instructions Manual