Advertisement
HANDS SPIN NON-STOP
This is indicative of a low or overpowered battery (number 1 warranty issue).
•
•
Replace battery and perform restart procedure. Allow 5 days to catch the WWVB
signal
•
If constant spinning continues, the movement may need replacement.
HANDS JUMPS OR JERKS AROUND THE DIAL
This is indicative of a low or overpowered battery (number 1 warranty issue).
•
Replace battery and perform the
•
signal.
If the hands continue to jump, the movement may need replacement.
•
HANDS STUCK AT CERTAIN TIME
This is indicative of a low or overpowered battery (number 1 warranty issue).
•
Replace battery and perform restart procedure. Allow up to 5 days to receive a signal.
•
Check to see if the hands may be bent.
•
•
Movement may need replacement.
HANDS ARE LOOSE.
If under warranty, the clock must be sent in for repair or the movement needs to be
•
replaced.
POSITION THE CLOCK
This La Crosse Technology
•
INDOOR: Select a location to place the radio-controlled clock where it will be at least
•
six feet away from a TV, computer, air conditioner or other household electrical
appliances. The optimal location is near a window. Windows facing Colorado provide the
best signal.
OUTDOOR: Select a location sheltered from direct sunlight and rain, preferably under
•
a roof or porch area, and facing Colorado for better reception of the WWVB signal.
This clock is designed for indoor and outdoor use: but only in a dry environment and in a
•
temperature range between -30°F and 130°F.
Note: The clock is NOT waterproof. If left in the elements water may enter the clock and
damage it.
HOW DO I ADJUST THE TEMPERATURE OR HUMIDITY?
With a flat tipped screwdriver, gently turn the temperature or humidity sensor screw at
•
the back of the clock to the desired setting.
La Crosse Technology, Ltd
restart
procedure. Allow up to 5 days to receive a
®
atomic clock is designed for indoor or outdoor use.
Page 4
Advertisement
