Operation; Operation Instructions - ZIPPER MASCHINEN ZI-STB13T User Manual

The plier is optional,
with bolts, flat
washers and nuts
mounted on the
drilling bench or the
baseplate.
13

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection for
damage and if tightened properly. Replace any damaged parts before operating the device.

13.1 Operation instructions

Perform all machine settings with the machine being
disconnected from the power supply!













ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STB13T
W A R N I N G
Do not attempt to drill material with the surface other than flat unless a
suitable support is available!
Never switch the machine on while pressing the drill bit against the
material!
Before switching the machine on, make sure that the table-clamping
lever is firmly tightened
Make sure that the bit is firmly clamped in the chuck
Due to the height of its own weight is the fixation of the drill press to
the ground requirement for less-vibration work.
Use a clip or clamping jaws to secure the piece to be drilled on the table
Set the drill to speed answering a specific job
Check the V-belts and tighten if necessary
Overtightening the belts can cause the motor to bind and not start. It
can also damage motor bearings!
In advanced wear of, replace V-belt
V-belts and pulleys may not come into contact with grease, oil or other
lubricants
Loosen the V-belt for a long break
After drilling guide the spindle back to the top position by hand.
A T T E N T I O N
N O T I C E
OPERATION
24