Assembly - ZIPPER MASCHINEN ZI-STB13T User Manual

12.3 Assembly

Place the column tube
on the baseplate. Bolt
the column tube to
the baseplate with the
three screws M8×20
supplied. Tighten the
screws moderately
tight with an open end
wrench SW 13 (not
scope of delivery) so
that the threads in the
baseplate do not strip.
Place the machine
head on the column
tube and secure the
machine head with
the two grub screws
to the side with the
allen key 4 mm.
Fold the drill chuck
guard upwards. Insert
the drill chuck on the
taper of the drill
spindle. Push the drill
chuck onto the drill
spindle with a few
light taps. Use a
plastic hammer for
this purpose.
Attach the drill chuck
key into the key
holder
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STB13T
Place the drilling bench
holder on the column tube.
Push the drilling Bench
holder into a lower position.
Fix the drilling bench holder
with the locking handle in
the required position.
Put the drill chuck guard on
the upper part of the drill
spindle. Secure the drill
chuck guard with a
screwdriver (not scope of
delivery).
Bolt the three drill lifting
arms into the hand spindle
guide. Tighten the three
hole- lifting arms with an
open end wrench SW 6 (not
scope of delivery).
1. Remove the washer and
nut from the depth stop.
See illustration 1.
2. Insert the depth stop
through the hole in the
fence. See illustration 2.
3. Screw the depth stop
with washer and nut (parts
from step 1)
4. Centrally align the depth
stop into the bore of the
fence. See illustration 3.
5.
The home position of
pointer should be 0mm.
See below illustration 4.
ASSEMBLY
23