Display Assembly Base - Dell Latitude XPiCD User Manual

A-18 Dell Latitude XPi CD Service Manual
5. Remove the LCD-inverter-board.
See "LCD-Inverter-Board Interface Cable" in Chapter 4.
6. Remove the display assembly base.
See "Display Assembly Base" later in this chapter.
7. Remove the display-assembly EMI shield.
The EMI shield is held in place by tabs along the upper and lower edges. Pull-
ing the center of the shield slightly away from the display assembly will release
the tabs.
To replace an EMI shield, carefully orient the replacement EMI shield in the
same position as the original shield. Make sure that all screw holes in the shield
are aligned with their corresponding screw holes in the display assembly case.

Display Assembly Base

To remove the display assembly base (see Figure 4-14), follow these steps:
1. Remove the display assembly from the computer.
See "Display Assembly" in Chapter 4.
2. Remove both hinge covers.
See "Hinge Covers" in Chapter 4.
3. Rotate the display assembly hinges so that they point away from the
display assembly at approximately 180 degrees.
4. Remove the display assembly bezel.
See "Display Assembly Bezel" in Chapter 4.
5. Remove the left hinge.
See the next subsection, "Display Assembly Hinges."
6. Rotate the right end of the display assembly base away from the display
assembly until the base clears the right hinge.
7. Lift the display assembly base away from the left hinge.
8. Disengage the display-assembly interface cable from the slot in the
base.