Mounting And Installation; Configuration - Pepperl+Fuchs HiD2024 Manual

Functional Safety HiD2024

Mounting and Installation

4 Mounting and Installation
Installing the device
1. Observe the safety instructions in the instruction manual.
2. Observe the information in the manual.
3. Observe the requirements for the safety loop.
4. Connect the device only to devices that are suitable for this safety application.
5. Check the safety function to ensure the expected output behavior.
4.1

Configuration

Configuring the Device Function
The function of the device is configured via DIP switches. The DIP switches are
on the side of the device.
1. De-energize the device before configuring the device.
2. Remove the device.
3. Configure the device for the required function via the DIP switches,
4. Secure the DIP switches to prevent unintentional adjustments.
5. Mount the device.
6. Connect the device again.
Adjusting the Signal Transfer of the Device
You can adjust the signal transfer accuracy via the potentiometers. The
potentiometers are on the front of the device.
1. Configure the device for the required function via the DIP switches,
2. Open the cover.
3. Calibrate the current transfer via the potentiometer.
4. Secure the potentiometers to prevent unintentional adjustments.
5. Close the cover.
Note!
For more information see the corresponding datasheets.
14
see chapter 3.3.
see above and chapter 3.3.