Setting Up The Monitor; Attaching The Stand - Alienware AW2521H User Manual

Setting up the monitor

Attaching the stand

NOTE: The stand is not factory-installed.
NOTE: The following instructions are only applicable for the stand that
was shipped with your monitor. If you are attaching a stand that you
purchased from any other source, follow the set up instructions that were
included with the stand.
CAUTION: The following steps are important to protect your curved
screen. Do follow the instructions below to finish up the installation.
1. Remove the stand riser and stand base from the packaging cushion.
2. Align and place the stand riser on the stand base.
3. Open the screw handle at the bottom of the stand base and turn it
clockwise to secure the stand assembly.
4. Close the screw handle.
Setting up the monitor | 29