Table of Contents
Advertisement
IP Environment Setup (Cont.)
Configuring a Wired Network Connection
Note: If desired, you can configure both wired and wireless connections.
However, note that a wired connection is always prioritized over a
wireless connection. That is, when the TV is turned OFF and then back
ON, if a Local Area Network (LAN) is detected by the TV, the TV will
default to the wired connection. If the LAN cable is removed, the TV will
then attempt to establish the wireless connection. Whenever the TV is
reconnected to the LAN, the TV will re-establish the wired connection.
1. Connect the appropriate cable between the TV and the network.
2. With the Network Menu on display, use the arrow keys on the
Installer Remote to select Network Setting. Then, press the Wheel
(OK) button. A Network Setting screen (see example at right), with
Wired and Wi-Fi Connection setup options, will be displayed.
By default, the TV uses DHCP, and if a LAN is detected, the TV will
request an IP address from the DHCP server on the network as soon
as you select "Network Setting" above. If the TV is able to connect
to the network, a "Connected to Internet" message will be displayed
below the Wired Connection (Ethernet) field.
3. If the network is not configured for DHCP or you want to specify
static IP configuration data or you would like to change the network
configuration from Manual to Automatic, edit the IP data for this TV
as follows:
• In the Network Setting screen, select Wired Connection (Ethernet)
and press the Wheel (OK) button. Then, in the Wired Connection
(Ethernet) screen, select Edit (if not already selected) and press
the Wheel (OK) button.
• In the Edit screen, select or de-select the "Set Automatically"
checkbox, as required. A checkmark indicates that Automatic
configuration is enabled.
• To manually edit the IP data, for each data entry field: Use the
arrow keys on the Installer Remote to select the field and press
the Wheel (OK) button. You can use the number keys on the
Installer Remote to direct enter numeric values or use the arrow
keys to select the appropriate numbers from the pop-up virtual
keyboard displayed at the bottom of the screen. (Note, however,
that you must use the dot "." key from the virtual keyboard to
separate each octet of an IP address.) When you are done, select
Enter from the virtual keyboard, and then press the Wheel (OK)
button on the Installer Remote.
• When all Edit fields are set as required, use the arrow keys on
the Installer Remote to select Connect and press the Wheel (OK)
button.
At the top of the screen, you will see a progress display that indicates
status as each network element is confirmed (see example at right).
66
NETWORK SETT...
Network
Network /
Pro:Centric
Wired Connection (Ethernet)
Not Connected
Portal Settings
Wi-Fi Connection
Not Connected
Media Share
WIRED CONN...
Network
Network / Network Setting /
Pro:Centric
DNS
Connected to Internet
Portal Settings
IP (Automatic)
IP Address
10.1.2.4
Media Share
Subnet Mask
255.255.255.0
Gateway
10.1.2.3
DNS Server
10.1.2.3
MAC Address
C8:08:E9:40:49:F5
EDIT
Network
Network / Network Setting / Wired Connection (...
Pro:Centric
DNS
Connected to Internet
Portal Settings
Set Automatically
10.1.2.4
IP Address
Media Share
255.255.255.0
Subnet Mask
10.1.2.3
Gateway
DNS Server
10.1.2.3
(Continued on next page)
EDIT
CONNECT
206-4334
Advertisement
Table of Contents
